A toupee, commonly known as hairpiece or hair replacement system, custom made and fitted replacement unit meant to cover up male pattern baldness. Wearing a custom toupee wig does not require any surgical procedures and is easily attached using either special hairpiece tape or bonding adhesives.
1. Clean the scalp by rubbing alcohol or witch hazel to remove natural body oils. Use witch hazel if you have dry or sensitive skin.
2. Apply the liquid toupee adhesive or toupee tape around the edges of the inside of the toupee. To apply liquid toupee adhesive, use an applicator brush to apply a thin layer of the adhesive to the edges of the toupee. Place a towel down under the toupee to prevent the adhesive from getting on counters. To apply toupee tape, stick the tape around the edges of the toupee and smooth the tape down. Ensuring that the tape does not stick out past the edges of the toupee. Once the tape is securely in place, remove the protective backing from the tape and apply.
3. Hold the toupee over your head and find the place where the toupee will sit.
4. Press the toupee down on your scalp and hold. Wait for the glue to dry or tape to stick in order for the toupee to stay in place.

5. Style the toupee as desired.

Learning how to clean your own hair system can save you a lot of time and money – and it’s easy to do. Rather than sending it into an expensive professional, follow our simple steps below and clean your scalp and hair system as often as you like. You'll look and feel much better, and of course look great!

How to Remove the Hair system
1. Spray or dab some hair adhesive remover on the bond area. 2. Peel the hair piece slowly from back to front. * Be careful not to pull too hard if you wear a polyurethane or skin hair toupee as you may damage the piece.* Please check if the hairpiece meets your requirements before use it, we could only accept return within 30 days for hairpieces not be used.

How to Clean your Hairpiece
Cleaning the Hairpiece Using the Mirror Slide Technique.
Used for: General cleaning of hair piece if it becomes dirty or full of glue.
Step 1
Get a mirror or a piece of glass. (This can also be done with a glossy page from a magazine)
Step 2
Place your hair piece with the hair side facing up, bottom side against the glass, and slowly slide it on the glass or mirror.
Step 3
Continue pressing gently but firmly until the glue appears on the mirror. Do several times.
Step 4
That’s it! Use a citrus or a cleaning agent like "Desolvit" to clean the mirror afterwards.

How to Shampoo and Condition Your Hairpiece
Follow these simple steps to shampoo and condition your hairpiece so it stays newer longer.
Step 1
After removing the glue and tape residual, rinse under medium warm running water, then in a bowl of clean warm water add some shampoo.
Step 2
Swish the piece around gently.
Step 3
Take out and rinse under running water until clear.
Step 4
Place in another bowl of clean warm water, add conditioner, let it soak for a few minutes, rinse again under running water until clear.
Step 5
Put on a form and comb out and let dry, spray on Velvasil, which is a leave on conditioner with sunscreen.